[hackspacebristol] Laser inductions - how to arrange?

Alaric Snell-Pym alaric at snell-pym.org.uk
Fri Jan 11 15:55:04 UTC 2013


-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On 01/11/2013 03:48 PM, Toby wrote:
> thanks Patrick, I'll check it out.

It is a wiki, after all :-)

Please contribute to the checklist I put on there, and add any
experience you gain to the material parameters list!

I want to try some of that yellow plastic next week... Any tips on
recommended settings for it would be gratefully received :-) And should
I remove the backing film before cutting? And if not, do I put that on
the bottom or top side? I'm thinking it'd be good on the bottom to keep
the honeycomb from scratching the plastic...

ABS

- --
Alaric Snell-Pym
http://www.snell-pym.org.uk/alaric/
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.11 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org/

iEYEARECAAYFAlDwNdcACgkQRgz/WHNxCGpuTACbBQ+FyaozOeDazLLNgGy25T3Y
EnMAn3tLtZJ63Ex6Jc8EbZa57oe0e5fq
=pxy3
-----END PGP SIGNATURE-----



More information about the Hackspacebristol mailing list