[hackspacebristol] 3D Printer Size

Tom Cook tom.k.cook at gmail.com
Tue Jun 18 07:56:03 UTC 2013


Blast, with the attachment this time...


On Tue, Jun 18, 2013 at 8:55 AM, Tom Cook <tom.k.cook at gmail.com> wrote:

> Hi Ian,
>
> Thanks for having a look.  The attached scad file is what I had in mind.
>  I'm not sure how the printer will go printing the cylinder - any thoughts?
>
> The part is to replace a joiner on a pram that's broken.  I'm not sure
> whether to just print the part as-is, or whether to print a negative mould
> and then cast in resin (perhaps with glass fibre).  Any thoughts?
>
> Thanks again,
> Tom
>
>
> On Mon, Jun 17, 2013 at 11:42 PM, Ian Stratford <ginjaian at gmail.com>wrote:
>
>> That's the volume; X and Y 200mm, Z around 110mm, max. But it depends
>> what you want to print as to the potential success/failure. Large parts can
>> warp if not carefully managed during the print. If you have something
>> specific in mind, run it by me and I'll try to work out if it's feasible.
>>
>> Ian
>>
>>
>> On Mon, Jun 17, 2013 at 11:27 PM, Jon Dowling <chocojon at blueyonder.co.uk>wrote:
>>
>>> I think the bed is 200mm by 200mm and probably greater than 100mm in
>>> build height. Ian would know better build volumes though.
>>>
>>> Hope that helps,
>>> Jon
>>>
>>>
>>> On 17 June 2013 13:28, Tom Cook <tom.k.cook at gmail.com> wrote:
>>>
>>>>  Quick question: what's the printable space of the 3D printer?
>>>>
>>>> Cheers,
>>>> Tom
>>>>
>>>> _______________________________________________
>>>> Hackspacebristol mailing list
>>>> Hackspacebristol at lists.aktivix.org
>>>> https://lists.aktivix.org/mailman/listinfo/hackspacebristol
>>>>
>>>>
>>>
>>> _______________________________________________
>>> Hackspacebristol mailing list
>>> Hackspacebristol at lists.aktivix.org
>>> https://lists.aktivix.org/mailman/listinfo/hackspacebristol
>>>
>>>
>>
>> _______________________________________________
>> Hackspacebristol mailing list
>> Hackspacebristol at lists.aktivix.org
>> https://lists.aktivix.org/mailman/listinfo/hackspacebristol
>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.aktivix.org/pipermail/hackspacebristol/attachments/20130618/8f6c1260/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: buggy.scad
Type: application/octet-stream
Size: 767 bytes
Desc: not available
URL: <https://lists.aktivix.org/pipermail/hackspacebristol/attachments/20130618/8f6c1260/attachment.obj>


More information about the Hackspacebristol mailing list